Reserve a clearance of at least 500 mm from the top of the cabinet for operations. Reserve a clearance of at least 500 mm from the rear of the cabinets for ventilation. If the UPS will be operated from the
Depending on the precise position and how close it is to the connected load, different types and amounts of site preparation may be necessary. The UPS should ideally be installed close
The minimum horizonal spacing requirement is 30 cm (12 inches) between two EG4-LL, EG4-LL-S and/or LifePower4 6 slot battery cabinet pairs as shown in Figure 2.
Working space shall be measured from the edge of the battery cabinet, racks, or trays. For battery racks, there shall be a minimum clearance of 25 mm (1 in.) between a cell container and any wall or
If you''re installing a smaller UPS behind a larger UPS, you must consider the total potential power of the smaller UPS as well as other loads that will be powered by the larger UPS.
Most batteries with greater runtime capacity are also physically larger, requiring a larger battery cabinet or rack. If your current UPS battery cabinet cannot store the larger batteries needed for the upgrade,
NOTE: The distance between the modular battery cabinet (s) and the UPS must not exceed 100 m. Contact Schneider Electric for installations with a longer distance.
Floor loading of UPS will vary based on the capacity and the type of the UPS. If there is a raised floor, the weight of the entire UPS system may require a concrete base to be installed upon. It is important
The UPS cabinets use forced air cooling to regulate internal component temperature. Air inlets are in the front of the cabinet and outlets are in the top. Allow clearance in front of and above each cabinet for
Clearances This table below lists minimum clearances for indoor primary and power cabinets to an adjacent building or parts/cabinets.
PDF version includes complete article with source references. Suitable for printing and offline reading.
